Konica Minolta bizhub PRESS C8000e User Manual
Page 563
bizhub PRESS C8000/e
11-17
11.2
[Controller] - [01 Controller NIC Setting Menu]
11
*2:
Selecting [Disable] for "IPv6 Setting" disables this function, even if [Enable] is selected for "IPv6
Auto Setting." In PSWC (PageScope Web Connection), the drop-down list of "IPv6 Auto Set-
ting" appears dimmed to show inactivity.
*3:
Selecting [Disable] for "IPv6 Auto Setting" enables the setting change of "Global Address," Pre-
fix Length," and "Gateway Address."
*4:
Unavailable for the ranges from fe80: : to febf: ffff: ffff: ffff: ffff: ffff: ffff: ffff, and from ff00: : to
ffff: ffff: ffff: ffff: ffff: ffff: ffff: ffff.
*5:
XXXX will be calculated from the MAC address.
*6:
Unavailable only for the range from fe80: 0: 0: 0: : to fe80: 0: 0: 0: ffff: ffff: ffff: ffff.
*7:
The characters between periods should be 63 characters at maximum. Use periods to connect
the character strings to make the entry up to 251 (253 including host name) characters.
*8:
In PSWC, place/remove a check mark to enable/disable the setting.
*9:
Only one IP address, not a range, can be permitted/denied in three ways.
For example, to permit/deny 192.168.11.22 only, enter:
192.168.11.22 - 0.0.0.0
0.0.0.0 - 192.168.11.22
192.168.11.22 - 192.168.11.22
*10:
This setting may be unavailable depending on the set combination of "Security Protocol," "ESP
Encryption Algorithm," and "Authentication Algorithm."
In PSWC, an alarm message appears for unavailable combination.
If an error is found in PSWC, a message will be displayed.
*11:
"Discovery User Name" cannot be specified with the same entry as that for "Read User Name"
or "Write User Name."
*12:
The tunnel mode in ESP AH setting is not supported.
*13:
When using Scan to SMB on Mac OS 10.7 or 10.8, "NTLM Setting" is required to be set to
"NTLMv2" and "NTLMv1/NTLMv2."