Konica Minolta bizhub PRESS C8000e - Manual (Page 339)

bizhub PRESS C8000/e 9-21
9.4 [03 Finisher Adjustment] (Finisher FS-521) 9
9.4.2 [01 Staple Finisher Adjustment] - [02 Paper Width Adj. (Staple)]
Adjust the width of stacker adjustment plates of the finisher to be used in Staple mode.
Objects of adjustment: Full Area, SRA3 w, A3 w, B4 w, SRA4 w/v, A4 w/v, B5 v, A5 v, 12 e 18 w, 11 e 17
w, 8.5 e 14 w, 8.5 e 11 w/v, 8.125 e 13.25 w, 8.5 e 13 w, 8.25 e 13 w, 8 e 13 w, 8K w, 16K v, 9 e 11 v,
Custom (380-460 mm), Custom (220-379 mm), Custom (148-219 mm)
NOTICE
With [Full Area] selected, the entered value will be applied to all sizes. With a specific paper size selected, set
value will be the sum of the entered value and the value previously specified for [Full Area].
1
Press [Adjustment] on the Machine Screen to display the Adjustment Menu Screen.
2
Press [03 Finisher Adjustment], [01 Staple Finisher Adjustment], and [02 Paper Width Adj. (Staple)] in
sequence.
The Paper Width Adjustment (Staple) Screen will be displayed.
3
Select the size to be adjusted using [+] and [,] to scroll.
4
Press [Print Mode].
5
Load the paper size to be adjusted into a tray, then select that tray key.
6
Press Start on the control panel. A sample pattern will be output.
7
Open the finisher door, and then withdraw the staple unit.
% When using paper with a length of 239 mm or longer, the staple unit cannot be withdrawn. Remove
the output paper from the delivery end, withdraw the staple unit, and then reset the paper in the unit.