Konica Minolta bizhub PRESS C8000e - Manual (Page 629)

bizhub PRESS C8000/e 12-55
12.8 [Network] Tab 12
2
Click [OK] to complete the setting.
Click [Cancel] to cancel the setting and clear the specified information.
3
Click [OK] on the setting complete page.
12.8.27 IEEE802.1X Authentication Setting - IEEE802.1X Authentication Trial
Click [IEEE802.1X Authentication Setting] and [IEEE802.1X Authentication Trial] in sequence on the menu of
[Network] tab to display this page.
Perform the trial of IEEE802.1X authentication.
1
If [OFF] is selected for the IEEE802.1X Authentication Setting, the IEEE802.1X Authentication Trial can-
not be performed. Press [Access IEEE802.1X Authentication Setting] to switch it to [ON].
2
Press [Authentication Trial].
The current authentication status will be displayed in [Authentication Status]. Refer to the table below
for confirmation.
[Validity Period] Specify whether or not to check that the server certificate
is not past the expiration date.
[CN] Specify whether or not to check that the CN of server
certificate is identical with the address of the server. To
check the CN, specify [Server ID].
[Server ID] Enter the server ID (up to 64 alphanumeric characters).
This setting is required when the CN of server certificate
is verified. Whether or not to
verify the CN of the
server certificate
[Network Stop Time] All network communications will stop if authentication
cannot be completed within a specified period. Put a
check mark to specify the period of time to elapse before
the network communication stops since the authentica-
tion process started.
[Stop Time] Specify the period of time to elapse before the network
communication stops since the authentication process
started.
To make it recognize again after the network communi-
cation stops, turn the main power switch off then on.
Specification Description Prior confirmation