ADTRAN 5000 Series - Manual (Page 1006)

Command Reference Guide Tunnel Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 1006
ip pim-sparse dr-priority <priority number>
Use the ip pim-sparse dr-priority command to specify the priority for the designated router (DR). This
command modifies the routers priority in the DR election process. Use the no form of this command to
return to the default value.
Syntax Description
<priority number> Specifies the priority number for the DR router. Valid range is 1 to 4,294,967,295.
Default Values
By default, the DR priority is set to 1.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example sets the DR priority to 5:
(config)#interface tunnel 1
(config-tunnel 1)#ip pim-sparse dr-priority 5