ADTRAN 5000 Series - Manual (Page 647)

Command Reference Guide Demand Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 647
demand-hold-queue <packets> timeout <seconds>
Use the demand-hold-queue timeout command to set the number and length of time interesting packets
will be held while a connection is being made. Use the no form of this command to restore the default
values.
Syntax Description
<packets> Specifies the number of packets that may be stored in the hold queue. Range is 0
to 100.
<seconds> Specifies the number of seconds a packet may remain in the hold queue. Range
is 0 to 255 seconds.
Default Values
By default, the hold queue is disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example configures demand interface 1 to hold 50 packets in the queue for up to
120 seconds:
(config)#interface demand 1
(config-demand 1)#demand-hold-queue 50 timeout 120