ADTRAN 5000 Series - Manual (Page 383)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 383
ip host <name> <address1>
Use the ip host command to define an IP host name. This allows you to statically map host names and
addresses in the host cache. Use the no form of this command to remove defined maps.
Syntax Description
<name> Defines the name of the host.
<address1> Specifies IP address associated with this IP host.
Default Values
By default, the host table is empty.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Functional Notes
The name may be any combination of numbers and letters as long as it is not a valid IP address or does
not exceed 256 characters.
Usage Examples
The following example defines two static mappings:
(config)#ip host mac 10.2.0.2
(config)#ip host dal 172.38.7.12