Access-policy <policyname – ADTRAN 5000 Series User Manual

Page 784

Advertising
background image

Command Reference Guide

HDLC Command Set

61200990L1-35E

Copyright © 2005 ADTRAN

784

access-policy <policyname>

Use the access-policy command to assign a specified access policy for the inbound traffic on an interface.
Use the no form of this command to remove an access policy association.

Syntax Description

<policyname>

Identifies the configured access policy by alphanumeric descriptor (all access
policy descriptors are case-sensitive).

Default Values

By default, there are no configured access policies associated with an interface.

Applicable Platforms

This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.

Command History

Release 9.1

Command was introduced.

Functional Notes

To assign an access policy to an interface, enter the interface configuration mode for the desired interface
and enter access policy <policy name>.

Usage Examples

The following example associates the access policy UnTrusted (to allow inbound traffic to the Web server)
to the HDLC interface labeled 1:

Enable the AOS security features:

(config)#ip firewall

Create the access list (this is the packet selector):

(config)#ip access-list extended InWeb

(config-ext-nacl)#permit tcp any host 63.12.5.253 eq 80

Configured access policies will only be active if the ip firewall command has been entered
at the Global Configuration mode prompt to enable the AOS security features. All
configuration parameters are valid, but no security data processing will be attempted
unless the security features are enabled.

Advertising