Network <address> <subnet mask – ADTRAN 5000 Series User Manual
Page 1137
Command Reference Guide
Router (RIP) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1137
network <address> <subnet mask>
Use the network command to enable RIP on the specified network. The AOS will only allow processing
(sending and receiving) RIP messages on interfaces with IP addresses that are contained in the networks
listed using this command. All RIP messages received on interfaces not listed using this command will be
discarded. To allow for receiving and participating in RIP but not for transmitting, use the
passive-interface command (refer to passive-interface <interface>
). Use the no form of this
command to remove a network from the list.
Syntax Description
<address>
Specifies the IP address of the network on which RIP will be enabled.
<subnet mask>
Specifies the subnet mask that corresponds to the entered IP address.
Default Values
By default, RIP is not enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1
Command was introduced.
Usage Examples
The following example enables RIP on the 102.22.72.252/30, 192.45.2.0/24, and 10.200.0.0/16 networks:
(config)#router rip
(config-rip)#network 102.22.72.252 255.255.255.252
(config-rip)#network 192.45.2.0 255.255.255.0
(config-rip)#network 10.200.0.0 255.255.0.0