ADTRAN 5000 Series - Manual (Page 523)

Command Reference Guide E1 Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 523
snmp trap threshold-reached
Use the snmp trap threshold-reached command to control the Simple Network Management Protocol
(SNMP) variable adGenAOSDs1ThresholdReached (adGenAOSDs1-Ext MIB) to enable the interface to
send SNMP traps when a DS1 performance counter threshold is reached. Use the no form of this command
to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the adGenAOSDs1ThresholdReached OID is enabled for all interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example disables SNMP threshold reached trap on the E1 interface:
(config)#interface e1 1/1
(config-e1 1/1)#no snmp trap threshold-reached