ADTRAN 5000 Series User Manual
Page 219
Command Reference Guide
Enable Mode Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
219
The following example shows sample output from the show ip pim-sparse rp-map command:
>enable
#show ip pim-sparse rp-map
Number of group-to-RP mappings: 5
Group address
RP address
---------------------------------------------------------
225.1.0.1
192.168.0.254
225.1.0.2 192.168.0.254
225.1.0.3
192.168.0.254
The following example shows sample output from the show ip pim-sparse rp-map set command:
>enable
#show ip pim rp-map set
Group address
Static-RP-address
--------------------------------------------------------------
224.0.0.0/4
192.168.0.254
MCAST_ACL_1 192.168.1.254
MCAST_ACL_2
192.168.2.254
MCAST_ACL_3
192.168.3.254
The following example shows sample output from the show ip pim-sparse state command:
>enable
#show ip pim-sparse state
PIM-SM State Table
Flags: S - Sparse, C - Connected, P - Pruned, J - Join SPT, T - SPT-bit Set,
F - Register, R - RP-bit Set
Timers: Uptime/Expires
(*, 225.1.0.1), 02:42:03/00:03:04, RP 192.168.0.254, Flags: SC
Forwarding Entry: Yes
Incoming interface: tunnel 2, RPF nbr 172.16.2.10
Upstream Join/Prune State: Joined
Register State: No Info
RegStop Timer (sec): stopped
Join/Prune Timer (sec): 57
Override Timer (sec): stopped
Multicast Border Router: 0.0.0.0
Packets Forwarded: 2
Outgoing interface list: