ADTRAN 5000 Series - Manual (Page 245)

Command Reference Guide Enable Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 245
show qos map
The show qos map command outputs information about the quality of service (QoS) map. This
information differs based on how a particular map entry is defined.
Variations of this command include the following:
show qos map
show qos map <map name>
show qos map <map name> <sequence number>
show qos map interface <interface id>
Syntax Description
<map name> Specifies the name of a defined QoS map.
<sequence number> Specifies one of the map’s defined sequence numbers.
<interface id> Displays the QoS map information for a specific interface (e.g., Frame Relay,
PPP, or ATM). Enter the show qos map interface ? command for a complete list
of interfaces.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 6.1 Command was introduced.
Release 9.1 Command was expanded to include HDLC interface.
Release 11.1 Demand interface was added.