Andrew ES45T - Manual (Page 16)

Step 5
Step 6
16
Loosely attach support angles (P/N 49622) to the upper azimuth axis joint (P/N 300748)
and the connection plates (part of P/N 49635)as shown in Figure 8.
•
Use A-325 ½ x 1-½ in. bolts, flatwashers and nuts. (see page 12)
•
Angles should be attached with flat of angle facing upward
•
Loosely attach support angles to azimuth axis joint (P/N 49629)
Installation Procedures
Figure 8
Apply a liberal amount of grease (P/N 49208) to azimuth axis support (P/N 49634) and
corresponding underside of azimuth axis joint as shown in Figure 9.
Figure 9
300748
UPPER