Andrew ES45T - Manual (Page 47)

Step 3
Step 4
47
Installation Procedures
Note: All six reflector segments are identified individually by a two letter designation (A-
B, D-E, etc). Locate the markings on the reflector segments in order to assemble the
reflector in the proper sequence. See Figure 55.
Figure 55
Place reflector segment A-B between two setting bands with concave side down as
shown in Figure 56. Place reflector segment D-E opposite panel A-B.
Figure 56
Raise segments and hold while loosely attaching mounting ring hub (P/N 202429) to
convex side of center opening.
•
Use ¼-20 capscrews. lockwashers and nuts
•
Insert capscrews from concave side of reflector segments
ES45T-T Reflector Assembly