Andrew ES45T - Manual (Page 39)

Reflector-to-Mount
Assembly
(With Hoist Kit)
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
39
Installation Procedures
The optional hoist kit (P/N 49080) must be assembled prior to reflector/ backstructure
assembly hoisting. Hoist assembly should not be used for antenna elevation angle
adjustment. The following steps provide the procedure for installing the reflector with the
hoist kit.
Install support tab assembly (P/N 49067) into top of azimuth axis support (P/N 49634)
as shown in Figure 47.
Figure 47
Loosely attach corresponding support assemblies (P/N 49071 and 49072) using spacers
(P/N 49059) and appropriate hardware (P/N 45980-6).
•
Angles should be installed edge down with flat of angles facing upward.
Install sheaves (P/N 49087) at each end between support assemblies using pins (P/N
39527) with cotter pins (P/N 9958-6). Securely tighten support assembly hardware.
Attach entire support assembly to previously installed support tab assembly (P/N 49067)
using appropriate hardware (P/N 45980-6).
Loosely attach pick-up assemblies (P/N 49064) to support and elevation pivot assembly
(P/N 49635) as shown.
•
Use supplied U-bolts with 1/2 inch (13 mm) lockwashers and nuts.
•
Pick-up assemblies are mounted with slanted tabs facing outward.
Loosely attach supports (P/N 49061) to corresponding tabs on support assemblies (P/N
49071 and 49072) using appropriate hardware (P/N 45980-1).
•
Angles are installed edge down with flat of angles facing upward
ES45T-R Reflector Assembly