Andrew ES45T - Manual (Page 33)

Step 2
Step 3
33
Installation Procedures
Loosely attach tee plates (P/N 202447) to points B, F and D on convex side of reflector
as shown in Figure 35.
•
Use A-325 ½ x 1-¼ in. bolts, flatwashers and nuts. (see page 12).
•
Insert bolts from concave side of reflector
Figure 35
Loosely attach plates (P/N 49427) to points A, C and E on convex side of reflector.
Loosely attach two support angles (P/N 49438) to each of six plates as shown in Figure
36.
•
Use A-325 ½ x 1-¼ in. bolts, flatwashers and nuts. (see page 12)
•
Install bolts from concave side of reflector
•
Angles should be installed with flat side towards back side of reflector
Figure 36
ES45T-R Reflector Assembly