Andrew ES45T User Manual
Page 18
Advertising
Step 10
Step 11
Step 12
18
Use a carpenter’s level to level support assembly as indicated in Figure 12. Loosen U-
bolts to move support assembly up or down as needed to achieve level surface.
Installation Procedures
Figure 13
Figure 12
Tighten anchor bolts on rear pads and azimuth axis support base plate down using A-
325 procedure. See A-325 procedure for technique. (see page 12)
Loosely attach elevation strut (P/N 49766) to azimuth axis joint (P/N 300746) as shown
in Figures 13 and 14.
•
Use ¾ x 3-½ in. bolt, lockwasher and nut
Advertising