Andrew ES45T - Manual (Page 27)

Step 10
Step 11
27
Installation Procedures
Loosely attach reflector segment B-C to mounting ring hub and diameter setting bands.
Use joining plates (P/N 49425) along B-B panel seam and joining plate (P/N 49693) on
B-B rim seam.
Before last panel, lift reflector and return temporary supports to initial measuring posi-
tion. Have installer inside reflector ensure setting bands are uniformly taut at this point.
If not, adjust level by adding shims until no segment of the reflector can bounce and set-
ting bands are uniformly taut, as shown in Figure 28.
ES45T-R Reflector Assembly
Top
A A
B
B
C
C
D D
E
E
F
F
200215
Shim
200215
Shim
200215
Shim
200215
Shim
200215
Shim
Foundation Pad
Move Reflector Segment in This Direction
to Enable Hardware Installation at B
Move Reflector Segment
in This Direction to
Enable Hardware
Installation at C
Rear View
Reflector Rib
Segments
200215
Shim
Figure 28A
Figure 28B