Andrew ES45T - Manual (Page 50)

Step 9
Step 10
Step 11
50
Installation Procedures
Station an installer inside reflector to finger-tighten seam hardware and attach final pan-
els as shown in Figure 59.
Figure 59
Loosely attach reflector segment B-C to mounting ring hub and diameter setting bands.
Use edge joining plate (P/N 49424) on B-B panel seam and joining plate (P/N 49693)
on B-B rim seam.
Before attaching last panel, lift reflector and return temporary supports to initial measur-
ing position. Have installer inside reflector check tension on diameter setting bands. If
not uniformly taut, adjust level by adding shims until no segment of the reflector can
bounce and bands are uniformly taut, as shown in Figure 60.
Figure 60
ES45T-T Reflector Assembly