Boss Audio Systems Boss CDSM AMP EFFECTS PROCESSOR GT-100 - Manual (Page 25)

EFFECT
25
MASTER SETTING
These settings are applied to the overall patch .
MASTER SETTING
Parameter Value Explanation
PATCH LEVEL 0–200 Adjusts the volume of the patch .
MASTER BPM 40–250
Adjusts the BPM value for each patch .
* BPM (beats per minute) indicates the number
of quarter note beats that occur each minute .
* When you have an external MIDI device
connected, the MASTER BPM synchronizes to
the external MIDI device’s tempo, making it
impossible to set the MASTER BPM . To enable
setting of the MASTER BPM, set”SYNC
CLOCK” (p . 29) to INTERNAL .
MASTER KEY C (Am)–B (G#m)
This sets the key for the FX HARMONIST .
Major
Major
Minor
Minor
MASTER EQ
Parameter Value Explanation
MASTER LOW
GAIN
-20–+20 dB Adjusts the low frequency range tone .
MASTER HIGH
GAIN
-20–+20 dB Adjusts the high frequency range tone .
MASTER MID
FREQ
20 .0 Hz–10 .0 kHz
Specify the center of the frequency range
that will be adjusted by the MASTER MID
GAIN .
MASTER
MID Q
0 .5–16
Adjusts the width of the area affected by the
EQ centered at the MASTER MID FREQ . Higher
values will narrow the area .
MASTER MID
GAIN
-20–+20 dB Adjusts the middle frequency range tone .
AMP CONTROL
By connecting your guitar amp’s channel switching jack to the GT-100’s
AMP CONTROL jack, you can then use Amp Control to switch the amp
channel .
This combining of the GT-100 and the amp channels allows you to get an
even wider variety of distortion sounds . Since the Amp Control setting is
handled as one of the effects parameters saved to each individual patch, it
allows you to switch guitar amp channels with each patch .
Parameter Value Explanation
AMP
CONTROL
OFF
Guitar Amp
(Channel switching jack)
GT-100
(AMP CONTROL jack)
ON
Guitar Amp
(Channel switching jack)
GT-100
(AMP CONTROL jack)
* To determine how the amp channels are switched when the circuit is
open and shorted, refer to the amp owner’s manual, or actually confirm
the sounds by operating the amp .
* Note that, depending on the circuitry of the channel switching jack in
the guitar amp used, the Amp Control function may not operate .
* Since this is a single mono plug, it can’t switch a three-channel amp .
MEMO
With Amp Control, not only can you switch amp channels,
you can also use it to switch the amp’s effects on and off, like a
footswitch controller .