Boss Audio Systems Boss CDSM AMP EFFECTS PROCESSOR GT-100 - Manual (Page 28)

SYSTEM
28
PREFERENCE
Here you can specify whether settings for the type of connected amp and
preamp, control pedal, expression pedal, etc . will be independent for each
patch, or whether the same settings will be shared by all patches .
Parameter Value Explanation
OUTPUT
SELECT
PATCH, SYSTEM If this is set to PATCH, different settings can
be made independently for each patch . If this
is set to SYSTEM, the same settings will be
shared by all patches .
* Here, even if a CTL/EXP pedal that has been
set to SYSTEM is set to ASSIGN SOURCE (p .
32), that setting will be ignored . In the case
of the ACCEL/CTL pedal, in addition to the
above, settings for Manual mode (p . 37) will
also be ignored .
PREAMP PATCH, SYSTEM 1–3
ACCEL/CTL PATCH, SYSTEM
EXP PATCH, SYSTEM
EXP SW PATCH, SYSTEM
SUB CTL 1 PATCH, SYSTEM
SUB CTL 2 PATCH, SYSTEM
SUB EXP PATCH, SYSTEM
LCD
Here you can adjust the brightness of the characters in the display .
Parameter Value Explanation
CONTRST
LEFT
1–16 Higher values increase the brightness .
CONTRST
RIGHT
USB
Here you can make USB-related settings for when the GT-100 is connected
to a computer via USB .
USB audio flow
MIX
Level
OUTPUT
Level
GT-100
USB IN
USB OUT
INPUT
OUTPUT
Effect Chain
USB IN-OUT MODE: NORMAL
MIX
Level
OUTPUT
Level
Effect Chain
GT-100
USB IN
USB OUT
INPUT
OUTPUT
USB IN-OUT MODE: DRY OUT
INPUT
Level
OUTPUT
Level
Effect Chain
GT-100
USB IN
USB OUT
INPUT
OUTPUT
USB IN-OUT MODE: REAMP
Parameter Value Explanation
USB IN-OUT
MODE
Here you can specify the audio flow for USB input/output .
NORMAL
The guitar input will be sent through the
GT-100’s effects and output to the computer . The
input from the computer will be mixed with the
GT-100’s output, and then output .
DRY OUT
The sound of the guitar processed by the effects
will be monitored, while the guitar input will
be output to the computer without passing
through the GT-100’s effects . The input from the
computer will be mixed with the GT-100’s output
(effect-processed guitar sound) and then output .
REAMP
The sound being input from the computer will
pass through the GT-100’s effects, and then be
output from the GT-100’s OUTPUT and USB OUT .
With this setting, the guitar sound recorded on
the computer can be played back through the
GT-100’s effects and output from the GT-100’s
guitar OUTPUT and USB OUT .
* If REAMP is selected, the GT-100’s INPUT
cannot be used .