Boss Audio Systems Boss CDSM AMP EFFECTS PROCESSOR GT-100 - Manual (Page 8)

EFFECT
8
CUSTOM AMP SETTING
Parameter Value Explanation
CUSTOM TYPE
JC CLEAN This models the sound of the Roland JC-120 .
TW CLEAN This models a Fender Twin Reverb .
CRUNCH
This is a crunch sound that can faithfully
reproduce the nuances of picking .
COMBO DRIVE This is a combo amp sound that it suited to
sixties-style British rock .
COMBO LEAD
This is a lead sound of a combo tube amp typical
of the late ‘70s to ‘80s .
MS HiGAIN
This models the sound input to Input I on a
Marshall 1959 .
This is a trebly sound suited to hard rock .
MODERN
STACK
This original high-gain amp delivers thick lows
and intense distortion while still preserving the
sound’s clear definition .
CUSTOM CHAR -50–+50
+: For soloing
-: For backing
CUSTOM
BOTTOM
-50–+50
This controls the input sound’s low-frequency
range and adjusts the amount of distortion in the
low-frequency range .
CUSTOM EDGE -50–+50
This controls the input sound’s high-frequency
range and adjusts the amount of distortion in the
high-frequency range .
CUSTOM
PREAMP LOW
-50–+50 Adjusts the preamp section’s low-frequency tone .
CUSTOM
PREAMP HIGH -50–+50
Adjusts the preamp section’s high-frequency
tone .
CUSTOM SPEAKER SETTING
Parameter Value Explanation
CUSTOM
SP SIZE
5–15" Selects the size of speaker .
CUSTOM
SP NUMBER
x1, x2, x4, x8 Sets the number of speakers .
CUSTOM
CABINET
Selects the speaker cabinet type .
OPEN This is an open-backed cabinet
CLOSE
This type of cabinet features an enclosed rear
panel .
CUSTOM
COLOR LOW
-10–+10 Adjusts the speaker section’s low-frequency tone .
CUSTOM
COLOR HIGH
-10–+10
Adjusts the speaker section’s high-frequency
tone .
EQ
This adjusts the tone as a equalizer . A parametric type is adopted for the
high-middle and low-middle range .
Parameter Value Explanation
ON/OFF OFF, ON Turns this effect on/off .
LOW GAIN -20–+20 dB Adjusts the low frequency range tone .
HIGH GAIN -20–+20 dB Adjusts the high frequency range tone .
LEVEL -20–+20 dB Adjusts the overall volume level of the equalizer .
LOW-MID
FREQ
20 Hz–10 .0 kHz Specifies the center of the frequency range that
will be adjusted by the LOW-MID GAIN .
LOW-MID Q 0 .5–16
Adjusts the width of the area affected by the EQ
centered at the LOW-MID FREQ . Higher values
will narrow the area .
LOW-MID
GAIN
-20–+20 dB Adjusts the low-middle frequency range tone .
HIGH-MID
FREQ
20 Hz–10 .0 kHz Specifies the center of the frequency range that
will be adjusted by the HIGH-MID GAIN .
HIGH-MID Q 0 .5–16
Adjusts the width of the area affected by the EQ
centered at the HIGH-MID FREQ . Higher values
will narrow the area .
HIGH-MID
GAIN
-20–+20 dB Adjusts the low-middle frequency range tone .
LOW CUT
FLAT,
20 Hz–800 Hz
This sets the frequency at which the low cut filter
begins to take effect . When FLAT is selected, the
low cut filter will have no effect .
HIGH CUT
630 Hz–
12 .5 kHz, FLAT
This sets the frequency at which the high cut
filter begins to take effect . When FLAT is selected,
the high cut filter will have no effect .