Boss Audio Systems Boss CDSM AMP EFFECTS PROCESSOR GT-100 - Manual (Page 27)

SYSTEM
27
Parameter Value Explanation
EXP PEDAL
HOLD
OFF
The operational status of the EXP PEDAL’s
FUNC (p . 31) is not carried over when patches
are switched .
ON
If the EXP PEDAL’s FUNC (p . 31) are the same
between 2 patches, the operational status is
carried over when patches are switched .
For example, if EXP PEDAL FUNC is set to
FOOT VOLUME in both patches, the one
before and the one after the change, the
volume corresponding to the position the
pedal is in (angle) at the time of the patch
change will be maintained after the patch
change . On the other hand, if the patch being
changed to is set to WAH, the volume will be
in accordance with the value set within the
patch, and you’ll obtain a wah effect that is
in accordance with a value that reflects the
current position (angle) of the pedal .
KNOB LOCK OFF, ON
Specifies whether knob operations will be
disabled . If this is ON, knob operations will
be disabled .
NUM PEDAL
SW
OFF, TUNER,
Ch . A/B, OD SOLO,
A/B SOLO,
A&B SOLO
Selects the function that will be recalled
when you press the pedal of the same
number as the currently selected patch .
BANK EXTENT
MIN
P01–P50,
U01–U50
Sets the lower limit for the banks .
BANK EXTENT
MAX
P01–P50,
U01–U50
Sets the upper limit for the banks .
PEDAL
INDICAT
OFF, ON
If this is ON, all currently unlit pedal
indicators will blink dimly .
KNOB SETTING
Here you can assign the desired parameters to knobs [1]–[8] in the Play
Screen .
* The settings you make here are only for the knobs in the Play Screen .
Parameter Value
KNOB 1 OFF, PATCH, COMP SUSTAIN, COMP ATTACK, COMP LEVEL,
OD/DS DRIVE, OD/DS TONE, OD/DS E .LEV, OD/DS SOLO LV,
PRE A TYPE, PRE A GAIN, PRE A LEVEL, PRE A BASS, PRE A MID,
PRE A TREBLE, PRE A PRES, PRE A SOLO LV, PRE A MIC LEV,
PRE B TYPE, PRE B GAIN, PRE B LEVEL, PRE B BASS, PRE B MID,
PRE B TREBLE, PRE B PRES, PRE B SOLO LV, PRE B MIC LEV,
EQ LO CUT, EQ LOW, EQ LO-MID, EQ HI-MID, EQ HIGH, EQ HI CUT,
DELAY TIME, DELAY F .BACK,DELAY HI CUT, DELAY E .LEV,
DELAY D1TIME, DELAY D1F .BK, DELAY D1HICUT, DELAY D1LEV,
DELAY D2TIME, DELAY D2F .BK, DELAY D2HICUT, DELAY D2LEV,
CHORUS RATE , CHORUS DEPTH, CHORUS PREDLY, CHORUS E .LEV,
REVERB TIME, REVERB HI CUT, REVERB E .LEV, MASTER LOW,
MASTER MID, MASTER HIGH, PATCH LEVEL, PEDAL WAH LEV,
PEDAL PB LEV, DIV CH SELECT, SR SEND LEVEL, SR RTN LEVEL,
NS1 THRESH, NS1 RELEASE, NS2 THRESH, NS2 RELEASE,
GLOBAL EQ LOW, GLOBAL EQ MID, GLOBAL EQ HIGH
KNOB 2
KNOB 3
KNOB 4
KNOB 5
KNOB 6
KNOB 7
KNOB 8
Display of parameters you can set with KNOB
SETTING
The parameter names displayed in the Play screen are abbreviated .
For details about the parameter names, refer to the chart shown below .
Value Display Value Display
OFF OFF DELAY F .BACK DlyFBK
PATCH PATCH DELAY HI CUT DlyHC
COMP SUSTAIN CmpSUS DELAY E .LEV DlyELV
COMP ATTACK CmpATK DELAY D1TIME D1 TIM
COMP LEVEL CmpLEV DELAY D1F .BK D1 FBK
OD/DS DRIVE OD DRV DELAY D1HICUT D1 HC
OD/DS TONE OD TNE DELAY D1LEV D1 LEV
OD/DS E .LEV OD ELV DELAY D2TIME D2 TIM
OD/DS SOLO LV OD SLV DELAY D2F .BK D2 FBK
PRE A TYPE A:TYPE DELAY D2HICUT D2 HC
PRE A GAIN A:GAIN DELAY D2LEV D2 LEV
PRE A LEVEL A:LEV CHORUS RATE ChoRAT
PRE A BASS A:BASS CHORUS DEPTH ChoDPT
PRE A MID A:MID CHORUS PREDLY ChoDLY
PRE A TREBLE A:TRB CHORUS E .LEV ChoLEV
PRE A PRES A:PRES REVERB TIME RevTIM
PRE A SOLO LV A:SLV REVERB HI CUT RevHC
PRE A MIC LEV A:MLV REVERB E .LEV RevELV
PRE B TYPE B:TYPE MASTER LOW MT LOW
PRE B GAIN B:GAIN MASTER MID MT MID
PRE B LEVEL B:LEV MASTER HIGH MT HI
PRE B BASS B:BASS PATCH LEVEL PAT LV
PRE B MID B:MID PEDAL WAH LEV WahLEV
PRE B TREBLE B:TRB PEDAL PB LEV PB LEV
PRE B PRES B:PRES DIV CH SELECT CH A/B
PRE B SOLO LV B:SLV SR SEND LEVEL SR SND
PRE B MIC LEV B:MLV SR RTN LEVEL SR RTN
EQ LO CUT EQ LC NS1 THRESH NS1THR
EQ LOW EQ LOW NS1 RELEASE NS1REL
EQ LO-MID EQ LMD NS2 THRESH NS2THR
EQ HI-MID EQ HMD NS2 RELEASE NS2REL
EQ HIGH EQ HI GLOBAL EQ LOW GB LOW
EQ HI CUT EQ HC GLOBAL EQ MID GB MID
DELAY TIME DlyTIM GLOBAL EQ HIGH GB HI