BT VP1000 - Manual (Page 16)

BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
4 FULL TEST OF WHOLE SYSTEM
It is advisable to disable your Internal Siren for
this test. To do this, follow these instructions:
PRESS DISPLAY
Twice until the display shows
SYSTEM PROFILE.
Enter default PIN 2580 (or your
new PIN if you have chosen one).
Until display shows
SYSTEM SETTINGS.
Until display shows
BUILT IN SIREN.
Display shows SIREN ON.
Until display shows SIREN OFF.
Twice to confirm change.
Three times, then <ON> to return
to READY.
Now complete the full test of your BT Home
Monitoring system. If you are testing to ensure
all your chosen contacts receive alert messages,
remember to warn them in advance.
• Switch your BT Home Monitor System ON.
• Wait for the exit beeps to finish, then set off at
least one or two sensors, ideally the Movement
Detectors as these will react immediately.
• Shortly your home phone should ring, this is
the first part of the reporting process, to help
identify false alarms. Ignore this if you wish to
test that messages are being sent to
nominated contacts.
• If you are Contact 1 you will receive a phone
call, text message or e-mail or a combination
of alerts depending on the information that
was input at the time of registration. Respond
to the alert by following the instructions in the
alert messages.
Please remember to turn your Internal Siren back
on at this point.
Congratulations, your BT Home Monitor
VP1000 is now set up.
NEXT
SHOW / OK
NEXT
SHOW / OK
NEXT
SHOW / OK
SHOW / OK
SHOW / OK
15
SECTION
2
BT Sales
For assistance in purchasing any additional
accessories, please contact
BT Home Monitoring on 0800 587 8877
or visit http://www.bt.com/homemonitoring
BT Support
For help at any time, please consult the
troubleshooting section of this guide, or
call the BT Home Monitoring helpdesk on
0870 240 1979 – Open normal office hours.
Call charges will apply. Or email:
[email protected]
0
HOME