BT VP1000 - Manual (Page 32)

BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
You may at some point decide you do not wish
to use one or more of your wireless sensors.
To delete a sensor from the Control Panel, follow
these instructions.
PRESS DISPLAY
Until the display shows
SYSTEM PROFILE.
Enter your MASTER CODE –
if you have not selected a
personal PIN number, this will
be the default setting - 2580.
Display shows
ADD / DEL SENSOR.
Display shows SENSOR NO:--
Enter the Sensor number for
the sensor you wish to delete
e.g. 04 or press NEXT to scroll
through the list.
Display shows S (number):
DELETE.
Display shows
<OFF> TO CLEAR.
Display shows S (number):
Choose either:
To move to the next sensor.
Or
Three times, when <OK> to exit to
return to READY.
You may also wish to remove the battery.
Please remember to update your personal
account with this information so that your
monitoring service can report information
accurately. You can do this by ringing the
number shown on your registration form or
via your Internet account.
Add / Delete Keyfob
You can use up to 8 Keyfobs with the BT Home
Monitor VP1000. One is already supplied with
your BT Home Monitor VP1000, so an additional
7 users can be provided with a Keyfob.
The Keyfob numbers allocated should correspond
to the User Code numbers also allocated, i.e. user
number 3 who has a unique PIN code should have
Keyfob number 3. This will enable you to know
who responded to alerts and turned the system
on and off (if the Alarm On and Off status feature
is activated). See next section on
Communications Settings for more details.
Please be aware that Keyfobs allow your security
system to be switched on and off without the need
for a PIN number, so they should not be stored
in conjunction with your address. Also, please
ensure that Keyfobs are kept with the correct
owner if you want to identify who switched the
system on and off and when.
NEXT
SHOW / OK
NEXT
SHOW / OK
SHOW / OK
SHOW / OK
0
OFF
NEXT
0
HOME
31
SECTION
4