BT VP1000 - Manual (Page 42)

NEXT
SHOW / OK
NEXT
SHOW / OK
SHOW / OK
SHOW / OK
0
OFF
0
HOME
NEXT
BT Home Monitor ~ Issue 5 ~ 1st Edition ~ 26_01_ 04 ~ 5725
SELECTING A SENSOR SIGNAL
Decide if you want the sensor to make a sound
when triggered, when the system is switched off.
One useful application is to configure a sensor
on or near your front door to CHIME when it is
opened, so you know when someone has entered
your house.
Note that the chime function must be activated
by pressing the number 8 button on the Control
Panel keypad.
PRESS DISPLAY
Display shows
S (number): CHIME.
Choose by scrolling through:
1. Chime Off.
2. Melody Chime.
3. Sensor Name.
Display shows
SENSOR NO:(number).
Choose either:
To move to the next sensor.
Or
Three times then <OK> to exit
to return to READY.
DELETING A SENSOR
You may at some point decide you do not wish
to use one or more of your wireless sensors. To
delete a sensor from the Control Panel, follow
these instructions:
PRESS DISPLAY
Until the display shows
SYSTEM PROFILE.
Enter your MASTER CODE –
if you have not selected a
personal PIN number, this will
be the default setting – 2580.
Display shows
ADD / DEL SENSOR.
Display shows SENSOR NO:--
Enter the Sensor number for
the sensor you wish to delete
e.g. 04 or press NEXT to scroll
through the list.
Display shows
S (number): DELETE.
Display shows <OK> TO CLEAR.
Display shows
SENSOR NO (number).
Choose either:
To move to the next sensor.
Or
Three times then <OK> to exit
to return to READY.
You may also wish to remove the battery.
SHOW / OK
SHOW / OK
NEXT
NEXT
0
HOME
SECTION
5
41