Pioneer AVIC-X1BT - Manual (Page 133)

131
A
ppe
ndi
x
NA
VI/
A
V
Limitation of Functions for
Areas not Stored on the Disc
For areas not stored on the disc (unrecorded
areas), the functions will operate as follows:
Inoperable buttons for unrecorded areas
Page 22
Displaying the map
• Maps with a scale of between 25 m and 200 m
cannot be displayed. (If the scale was set to
between 25 m and 200 m, it is automatically
switched to 500 m.)
• When driving with Mixed Mode, St.List
Mode or Driver’s View, upon entering an
unrecorded area the display automatically
switches to Map Mode. (When the vehicle re-
enters an area stored on the disc, the display
returns to the previous map mode except for
Driver’s View.)
Destination search
• You cannot search a destination in an unre-
corded area using Address Search or Postal
Code Search.
• In case of POI Search and Vicinity Search,
only “City Centre” search is possible.
• If you cannot search in a currently selected
country, the system may forcibly switch to the
country selection screen.
• A Motorway Search covers all areas, regard-
less of the disc on which the information is
recorded.
• If a Vicinity Search is performed on the bor-
der of an unrecorded area, the system will not
necessarily select the nearest facility. (The
search will take place only within the range of
areas recorded on the disc.)
Guidance
• When your vehicle approaches an unrecorded
area, you will be notified three times: when the
distance to the unrecorded area is 20 km (12
mi), 10 km (6 mi) and 5 km (3 mi) respectively.
When your vehicle enters the unrecorded area,
a caution is given.
• In the unrecorded area, only guidance for
reaching the destination is provided. No other
guidance is given.
• If a route calculation is operated within an
unrecorded area, the route might not be set
from the streets you are currently driving. Also,
if you set the destination in an unrecorded area
of the disc, the system may not be able to set
the route up to the destination.
• If the vehicle deviates from the set route in an
unrecorded area, the Auto Reroute function
will not work.
• Even if “Close-up of Junction” is “On”, the
display will not switch to an enlarged map of
the junction.
• Even if you drive on the motorway, lane infor-
mation, motorway exit numbers and motorway
signs will not be displayed.
Route information
• If the set route goes through an unrecorded
area, no route profile for the unrecorded area
will be displayed. (If the set route traverses
both an unrecorded area and area stored on
the disc, only the route profile within the
recorded area will be displayed.)
• Route scrolling for an unrecorded area is pos-
sible only with a map scale of 500 m or above.
Other function limitations
Overlay POI
• Only the display “City Centre” is available in
an unrecorded area.
Memory mode
• Only data for areas stored on the disc can be
memorised. (Data for unrecorded areas cannot
be memorised.)
Avoid area
• An area not stored on the disc cannot be set as
an Area to Avoid.
A set Area to Avoid may be deleted when the
software is updated. If this happens, the sys-
tem will automatically try to recover the
deleted information, but data can be recov-
ered only for areas stored on the disc. For
items that could not be recovered, a recovery
process will begin when you set another disc.