Pioneer ANH-P10MP - Manual (Page 52)

RDS
En
05
Section
52
Using Auto PI Seek for preset
stations
When preset stations cannot be recalled, as
when travelling long distances, the unit can
be set to perform PI Seek during preset recall.
• The default setting for Auto PI Seek is off.
Refer to Switching the auto PI seek on
page 95.
Limiting stations to regional
programming
When AF is used to automatically retune fre-
quencies, the regional function limits the se-
lection to stations broadcasting regional
programmes.
1 Press FUNC and then press REG to se-
lect the regional mode.
2 Press REG to turn the regional function
on.
The light illuminates.
Press REG again to turn the regional function
off.
Notes
• Regional programming and regional net-
works are organized differently depending on
the country (i.e., they may change according
to the hour, state or broadcast area).
• The preset number may disappear on the dis-
play if the tuner tunes in a regional station
which differs from the originally set station.
• The regional function can be turned on or off
independently for each FM band.
Receiving traffic
announcements
TA (traffic announcement standby) lets you re-
ceive traffic announcements automatically,
no matter what source you are listening to. TA
can be activated for both a TP station (a sta-
tion that broadcasts traffic information) or an
enhanced other network’s TP station (a sta-
tion carrying information which cross-refer-
ences TP stations).
1 Tune in a TP or enhanced other net-
work’s TP station.
When you are tuned into a TP or enhanced
other network’s TP station the
TRFC indicator
will light.
2 Press TA to turn traffic announcement
standby on.
Press
TA and “ TRFC” appears in the display.
The tuner will stand-by for traffic announce-
ments.
If you turned TA function on while tuned in to
neither a TP nor an enhanced other network’s TP
station, only
“ T” in the TRFC indicator rights.
To turn traffic announcements standby off,
press TA again.
3 Use VOLUME to adjust the TA volume
when a traffic announcement begins.
Rotate to increase or decrease the volume.
The newly set volume is stored in memory and
recalled for subsequent traffic announce-
ments.
4 Press TA while a traffic announcement
is being received to cancel the announce-
ment.
The tuner returns to the original source but re-
mains in the standby mode until
TA is
pressed again.
You can also cancel the announcement by
pressing SOURCE, BAND/ESC, , , or
while a traffic announcement is being received.