Pioneer ANH-P10MP - Manual (Page 72)

Multi-CD Player
En
08
Section
72
4 When you find the desired track (or
disc), press SCAN to turn scan play off.
The light goes off. The track (or disc) will con-
tinue to play.
If the scan mode is automatically cancelled,
select the scan mode again.
Notes
• After track or disc scanning is finished, nor-
mal playback of the tracks will begin again.
• When the scan mode is exited while scan
play is on, “ SCAN” appears on the basic dis-
play.
Selecting tracks from the
track title list
The track title list lets you see the list of track
titles on a CD TEXT disc and select one of
them for playback.
1 Press FUNC and then press T.LIST to se-
lect the track title list mode.
2 Press NEXT until the desired track title
appears.
3 Press the corresponding number but-
ton to select the desired track title.
That selection will begin to play.
Notes
• You can also use , , (or NAVI/OK) to se-
lect and play the desired track title.
• Only when playing a CD TEXT disc on a CD
TEXT compatible multi-CD player, you can
switch to this mode.
Selecting discs from the
disc title list
The disc title list lets you see the list of disc ti-
tles and select one of them for playback. Dis-
played disc titles are those which have been
entered into the multi-CD player or recorded
on a CD TEXT disc.
1 Press FUNC and then press D.LIST to se-
lect the disc title list mode.
2 Press NEXT to switch between “1” –
“6” and “7” – “12”.
3 Press any of the buttons 1 – 6 (or 7 –
12) to select the desired disc title.
That selection will begin to play.
Notes
• You can also use , , (or NAVI/OK) to se-
lect and play the desired disc title.
• “ No disc” is displayed next to the disc
number when no disc is set in the magazine.
• If no title has been entered for a disc, “ No
D.Title” will be displayed.
• You cannot display “ 7” – “12” when a 6-disc
multi-CD player is connected.