Baldor GLC40 User Manual
Page 33
Receiving & Installation 3‐9
MN2408
Electrical Connections Class 1 wiring methods must be used for field wiring connections to terminals of a class
2 circuit. It is the responsibility of the owner/operator to arrange for these procedures to be
performed by a licensed electrical contractor and ensure conformance to all applicable codes
including local codes peculiar to your municipality/city/county and state. Wire size and insulation
type should be as required by NEC (National Electrical Code) and local codes.
Warning:
Never connect this generator to the electrical system of any building unless a licensed
electrician has installed an approved transfer switch. The national electrical code (NEC)
requires that connection of a generator to any electrical circuit normally powered by means of
an electric utility must be connected by means of approved transfer switch equipment to
isolate the electrical circuit from the utility distribution system when the generator is
operating. Failure to isolate the electrical circuits by such means may result in injury or death
to utility power workers due to backfeed of electrical energy onto the utility lines.
Warning:
Incorrect installation of this generator set could result in property damage, injury or death.
Connection of the generator to its fuel source must be done by a qualified professional
technician or contractor.
WARNING: Be sure the system is properly grounded before applying power. Do not apply AC power
before you ensure that grounds are connected. Electrical shock can cause serious or fatal
injury. NEC requires that the frame and exposed conductive surfaces (metal parts) be
connected to an approved earth ground. Local codes may also require proper grounding of
generator systems.
Intended Use The intended purpose of this generator set is to provide emergency power when the main utility
power supply is interrupted. Therefore, it is important that all the wiring that connects the generator
set with your house, transfer switch, distribution box, battery charger, etc. be properly installed.
Circuit Protection Circuit protection is not provided within the generator. Circuit Breaker protection is an option.
If purchased with your generator, the breaker box is mounted to the generator prior to shipment.
If the optional circuit breaker protection was not ordered, see “GLC Circuit Breaker & Wire Size
Data” in Appendix A for recommendations.
Wire Size
Proper lead wire from the circuit breaker to the automatic transfer switch (or load switching
device) is mandatory. See transfer switch information for connection information. When
connecting the generator output to an electrical load, a UL listed circuit breaker with the
appropriate ratings must be provided within 25 feet of the generator set. Use only copper wires.
Generator Rating
Input Breaker Rating (at 115% FLA)
Catalog No.
Kilowatt (kW)
Rating
1 Phase Amps
(240VAC) *
3 Phase Amps (240VAC) *
3 Phase Amps (480VAC) *
LPV/Nat. Gas
Delta (Wye)
Nat. Gas
Delta (Wye)
LPV
Delta (Wye)
Nat. Gas
Delta (Wye)
LPV
Delta (Wye)
GLC10
10
50
GLC15
15
70
GLC20
20
100
GLC25
25
125
GLC30
30
110
110
110
60
60
GLC35
35
125
125
125
60
60
GLC45
45
150
150
175
70
80
GLC50
50
175
175
175
90
90
GLC60
60
200
200
200(225)
100
110
GLC80
80
300
300
300
150
150
GLC100
100
300
300
350
150
175
GLC125
125
450
450
400
225
200