Baldor GLC40 - Manual (Page 80)

A‐2 Series GLC MN2408
Battery Heaters Battery Heater (BTHTR81) - 120 Volt / 80 Watt. Includes 6 ft power cord.
Installation Considerations:
Shore power must be available (120VAC or 240VAC) to power the battery heater and other
components that may be installed). Shore power outlets or wiring must be located close to
battery heater.
Figure A‐2 Battery Heating Pad Installation
BTHTR81 Heater
1. Carefully disconnect the Negative battery terminal from the battery.
2. Carefully disconnect the Positive battery terminal from the battery.
3. Remove battery hold down bracket.
4. Remove battery.
5. Install Heating Pad in battery tray, refer to Figure A‐2. The ”A” and ”B” dimesions
should match the battery tray.
6. Install battery on top of Heating Pad.
7. Install battery hold down bracket.
8. Carefully install the Positive battery terminal to the battery.
9. Carefully install the Negative battery terminal to the battery.
10. Connect the AC power cord to shore power outlet.