Boss Audio Systems BR-800 - Manual (Page 143)

143
Editing
Mastering
Using USB
Con
venient
Functions
Appendix
es
Quic
k Star
t
Getting Read
y
to Recor
d
Recor
ding/
Pla
ybac
k
Using Eff
ects
Using Rh
ythm
Adjusting the Sensitivity of the
Touch Sensors
The top panel of the BR-800 employs touch sensors. Over
time, depending on the location in which you use the BR-
800 and the type of usage you subject it to, you may notice a
decline in the response of these touch sensors, or find that
they’ve become unnecessarily sensitive. In such cases, you
should adjust the sensitivity of the sensors using the
following procedure.
1
Switch off the BR-800’s power.
2
Eject the SD card.
* For instructions on how to eject and insert SD cards, see p.
146, p. 147 in the Owner’s Manual.
3
Connect the AC adaptor.
* Make sure that the BR-800 is powered using the AC adaptor
while you are adjusting the sensitivity of the sensors.
4
Turn on the BR-800’s power.
After you turn on the power, make sure that you do not
touch any part of the top panel until the SW
SENSITIVITY (sensitivity adjustment) screen appears.
The SW SENSITIVITY screen (for adjusting the
sensitivity of the touch sensors) will appear.
5
Using the dial, adjust the sensitivity.
Range: 1–10
* When the instrument is shipped from the factory, this is set
to “5.”
6
Press the various buttons on the top panel to check
their sensitivity.
Press all of the buttons except the [EXIT] button and
[ENTER] button.
Using the dial, adjust the value until a button’s name
appears in the screen as soon as you press the button.
7
Once you’ve finished checking the sensitivity for all
the buttons, press the [ENTER] button.
If you want to exit without saving your settings, press
the [EXIT] button.
When you press the [ENTER] button
The message “Save and exit?” will appear, asking you
for confirmation.
To save your settings, press the [ENTER] button; to
return to the SW SENSITIVITY screen, press the [EXIT]
button.
When you press the [EXIT] button
The message “Quit without saving?” will appear,
asking you for confirmation.
If you don’t want to save your settings, press the
[ENTER] button; to return to the SW SENSITIVITY
screen, press the [EXIT] button.
8
Once the play screen appears, switch off the BR-800’s
power.
9
After confirming that the unit’s power is off, insert
the SD card.
BR800_e.book 143 ページ ２０１０年１１月２日 火曜日 午前８時２８分