Boss Audio Systems BR-800 - Manual (Page 78)

78
Using Insert Effects
CHORUS
In this effect, a slightly detuned sound is added to the
original sound to add depth and breadth.
DBL DELAY (Doubling Delay)
By adding a slightly time-delayed sound to the direct
sound, this produces the impression that multiple sources
are sounding together (a “doubling” effect). Best results will
be achieved when stereo recording.
Parameter/
Range
Explanation
MODE
Selection for the chorus mode.
MONO
This chorus effect outputs the same sound
from both L channel and R channel.
STEREO1
This is a stereo chorus effect that adds dif-
ferent chorus sounds to L channel and R
channel.
STEREO2
This stereo chorus uses spatial synthesis,
with the direct sound output in the L
channel and the effect sound output in the
R channel.
RATE
0–100 Adjusts the rate of the chorus effect.
DEPTH
0–100
Adjusts the depth of the chorus effect.
To use it for doubling effect, set the
value to 0.
PRE DELAY
0.0ms–40.0ms
Adjusts the time needed for the effect
sound to be output after the direct sound
has been output.
By setting a longer pre delay time, you can
obtain an effect that sounds like more than
one sound is being played at the same time
(doubling effect).
E.LEVEL (Effect Level)
0–100 Adjusts the volume of the effect sound.
Parameter/
Range
Explanation
DLY TME (Delay Time)
0.5–50.0 ms
This parameter adjusts the delay time (i.e.,
the interval for which sound is delayed).
SEPARATION
-50–+50
Adjusts the diffusion. The panning of the
direct sound and effect sound can be
spread to left and right.
This effect is obtained with stereo record-
ing (using two tracks).
E.LEVEL (Effect Level)
0–120 This adjusts the volume of the delay sound.
BR800_e.book 78 ページ ２０１０年１１月２日 火曜日 午前８時２８分