Boss Audio Systems BR-800 - Manual (Page 147)

147
SD Cards that Can Be Used with the BR-800
Editing
Mastering
Using USB
Con
venient
Functions
Appendix
es
Quic
k Star
t
Getting Read
y
to Recor
d
Recor
ding/
Pla
ybac
k
Using Eff
ects
Using Rh
ythm
4
To prevent the removed screw from being lost, use a
Phillips (+) screwdriver to attach it in the location
shown in the illustration below.
fig.CardSlot03.eps
■ Inserting an SD card
Insert the SD card so that its contacts are facing upward.
fig.InsCard.eps
■ Removing an SD card
Gently press the SD card inward, and then release your
finger.
The SD card will pop out slightly, allowing you to remove
it.
■ The SD card write protect feature
(LOCK)
The contents of the SD card can be protected by write
protecting it. To write protect a card, slide the write protect
switch on the side of the SD card to the “LOCK” position.
Unlock write protect to delete data on the SD card.
fig.SD_SW-e.eps
• When turning the unit upside-down, get a bunch
of newspapers or magazines, and place them
under the four corners or at both ends to prevent
damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or
controls get damaged.
• When turning the unit upside-down, handle with
care to avoid dropping it, or allowing it to fall or
tip over.
• Keep any screws or card cover you may remove
and the included SD card in a safe place out of
children’s reach, so there is no chance of them
being swallowed accidentally.
• Carefully insert the SD card all the way in—until
it is firmly in place.
• Do not touch the contacts of the SD card or allow
them to get dirty.
• Never insert or remove an SD card while this
unit’s power is on. Doing so may corrupt the
unit’s data or the data on the SD card.
Writing allowed
Writing prohibited (LOCK)
BR800_e.book 147 ページ ２０１０年１１月２日 火曜日 午前８時２８分