Side panel – Boss Audio Systems BR-800 User Manual
Page 18
18
Panel Descriptions
fig.SidePanel.eps
MEMORY CARD (SD card) slot
Insert an SD card. Recording is not possible unless an SD card is inserted.
“SD Cards that Can Be Used with the BR-800” (p. 146)
USB connector
This connector lets you connect the BR-800 to your computer via a USB cable. When connected to a computer, you’ll be
able to do the following things.
• Use the BR-800 as an audio interface and control surface
• Transfer audio data to and from the computer
• Create original rhythms and drum kits
• Back up your data
[POWER] switch
This is the power switch. It turns the BR-800’s power on/off (p. 34).
DC IN (AC adaptor) jack
Connect the included AC adaptor here (p. 32).
Side Panel
Position
Explanation
ON
Power is on, when using the included AC adaptor or batteries
OFF
Power is off
USB
Power is on, when connected via USB cable.
USB (bus power) can be used when the BR-800 is connected to your computer via a USB cable.
Power is supplied from your computer via the USB cable. If using bus power, set the power switch to
the USB position.
* Before you can power the unit via a USB bus, you first need to install the appropriate driver in your computer
* Depending on your computer, the BR-800 might not be able to operate using bus power. If so, please use the
included AC adaptor.
4
2
3
1
1
2
3
4
• Use only the included AC adaptor. Using any other adaptor may cause overheating and malfunction.
• Important data may be damaged if the AC adaptor is disconnected during use.
BR800_e.book 18 ページ ２０１０年１１月２日 火曜日 午前８時２８分