Boss Audio Systems BR-800 - Manual (Page 153)

Editing
Mastering
Using USB
Con
venient
Functions
Appendix
es
Quic
k Star
t
Getting Read
y
to Recor
d
Recor
ding/
Pla
ybac
k
Using Eff
ects
Using Rh
ythm
153
Troubleshooting
Can’t record
Could the song be protected? p. 108
Is an SD card inserted? p. 146
Could the SD card have insufficient free space? p. 140
Could the SD card be locked? p. 147
Could you be using the Phrase Trainer? p. 136
Could scrub playback be in use? p. 104
Could control surface mode be in use?
You can’t record on the BR-800 in control surface mode.
p. 121
You want to turn
off the reverb
Check the reverb send level amounts for the loop effect.
The BR-800 provides reverb as a loop effect.
Reverb is applied by default. If you want to turn off the reverb effect, set each track’s
send level amount to “0.”
p. 83
Recorded sound
contains noise or
distortion
Is the input sensitivity appropriate?
The recorded sound will be distorted if the input sensitivity is too high, and noise will
be excessive if the input sensitivity is too low. Adjust the input sensitivity so that the
PEAK indicator briefly lights when the loudest passages occur.
p. 37
Are the track output levels appropriate?
If there is noise or distortion following mastering, the track output levels are too high.
–
Could a microphone with high output impedance be connected directly to the BR-800?
Since the INPUT 1–4 jacks are designed for a low input impedance, the recording level
may be too low depending on the characteristics of the microphone. In this case, pass the
signal through a commercially available microphone preamp before recording it.
–
Oscillation occurs
Could INPUT SELECT be set to “USB”?
If INPUT SELECT is set to “USB,” the settings of your software may cause the audio sig-
nal to be looped. In this case, you can solve the problem by taking one of the following
actions.
• Stop playback in your software, or turn off the Soft Thru function.
• Turn off the audio input of your software.
• Change INPUT SELECT to a setting other than “USB.”
p. 37
Problems with the SD Card
Item Explanation Page
Data on the SD
card was damaged
Data on the SD card can be damaged due to the following reasons. Please format the SD
card.
• Could you have turned off the power while the recorder was operating?
• Could the SD card have been subjected to strong physical shock?
• Could you have turned off the power while the SD card was being accessed?
• Could you be using an SD card that was formatted by a computer or digital
camera?
p. 139
Item Explanation Page
BR800_e.book 153 ページ ２０１０年１１月２日 火曜日 午前８時２８分