Boss Audio Systems BR-800 - Manual (Page 76)

76
Using Insert Effects
PHASER
By adding varied-phase portions to the direct sound, the
phaser effect gives a whooshing, swirling character to the
sound.
FLANGER
The flanging effect gives a twisting, jet-airplane-like
character to the sound.
TREMOLO
Tremolo is an effect that creates a cyclic change in volume.
Parameter/
Range
Explanation
TYPE
Selects the number of stages that the phaser effect will use.
4 STAGE
This is a four-phase effect. A light phaser
effect is obtained.
8 STAGE
This is an eight-phase effect. It is a popular
phaser effect.
12 STAGE
This is a twelve-phase effect. A deep phase
effect is obtained.
BI-PHASE
This is the phaser with two phase shift cir-
cuits connected in series.
RATE
0–100 This sets the rate of the phaser effect.
DEPTH
0–100 Determines the depth of the phaser effect.
MANUAL
0–100
Adjusts the center frequency of the phaser
effect.
RESONANCE
0–100
Determines the amount of resonance (feed-
back). Increasing the value will emphasize
the effect, creating a more unusual sound.
STEP RATE
OFF, 0–100
This sets the cycle of the step function that
changes the rate and depth.
When it is set to a higher value, the change
will be finer. Set this to “OFF” when not us-
ing the Step function.
E.LEVEL (Effect Level)
0–100 Adjusts the volume of the phaser.
D.LEVEL (Direct Level)
0–100 Adjusts the volume of the direct sound.
Parameter/
Range
Explanation
RATE
0–100 This sets the rate of the flanging effect.
DEPTH
0–100 Determines the depth of the flanging effect.
MANUAL
0–100
Adjusts the center frequency at which to
apply the effect.
RESONANCE
0–100
Determines the amount of resonance (feed-
back).
Increasing the value will emphasize the ef-
fect, creating a more unusual sound.
SEPARATION
0–100
Adjusts the diffusion. The diffusion in-
creases as the value increases.
E.LEVEL (Effect Level)
0–100 Adjusts the volume of the flanger.
D.LEVEL (Direct Level)
0–100 Adjusts the volume of the direct sound.
Parameter/
Range
Explanation
WAVE SHAPE
0–100
Adjusts changes in volume level.
A higher value will steepen wave’s shape.
RATE
0–100
Adjusts the frequency (speed) of the
change.
DEPTH
0–100 Adjusts the depth of the effect.
BR800_e.book 76 ページ ２０１０年１１月２日 火曜日 午前８時２８分