Connecting ac power, Connecting dc power – Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 User Manual
Page 242
224
Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide53-1002373-02
Installing a Brocade MLX-32 router
3
For information about connecting power to the router, refer to
For information about powering on the system, refer to
Connecting AC power
NOTE
For the NEBS-compliant installation, AC power connections must use a surge protection device
(SPD) to protect the AC power supplies from damage due to excessive power line surges.
AC power is supplied through a power cord that is connected to each power supply in the Brocade
MLX router. Follow the steps below to connect AC power to a Brocade MLX-32 router.
1. Locate the power receptacle on the front panel of each installed power supply. Refer to
.
2. Lift the cord retainer and connect an AC power cord to the power supply.
3. Snap the cord retainer over the power plug to hold it in place.
FIGURE 160
Brocade MLX-32 power supply receptacle and cord retainer
Connecting DC power
You can supply DC power to the Brocade MLX-32 router with a DC-to-DC power supply. For 2400W
power supplies, DC power must be supplied at 48V and 60 A for 2400W. For 3000W power
supplies, power must be supplied at 48V and 90A. The 2400W DC-to-DC power supply provides the
DC power to the router at 12V and 200A. The 3000W DC-to-DC power supply provides DC power to
the router at 12V and 245A.
DANGER
The procedure in this section is for qualified service personnel.
Follow these steps to connect a DC power source:
1. Use a#1 Phillips screwdriver to remove the screw that secures the safety cover, as shown in
. Remove the safety cover.
1
Cord retainer
2
Power receptacle
AC OK
DC OK
ALM
1
2