Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 - Manual (Page 68)

50 Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide
53-1002373-02
Router modules
1
High-speed switch fabric modules
Gen-2 high-speed fabric (HSF) modules support wire-speed forwarding for all packet sizes,
including jumbo frames.
NOTE
Gen-1 switch fabric modules and Gen-2 HSF module are not compatible and will not operate
together in the same device.
HSF modules are supported on Brocade MLX Series and Brocade NetIron XMR routers, and are
interoperable with all existing interface modules.
HSF modules are hot-swappable, which means you can install or replace them while the system is
powered up and running.
NOTE
Hot-swapping or installing high-speed switch fabric modules one-at-a-time may affect the
performance of 2x100GbE interface modules. If you have 2x100GbE modules in your device, it is
recommended that you bring your system down and install all required high-speed switch fabric
modules before you bring the system back up.
HSF modules can operate in normal mode or turbo mode but will boot in turbo mode only if all
active interface modules are Gen-2 modules. For a list of Gen-1 and Gen-2 modules, refer to
Table 3 .
Power supplies
Brocade offers the following power supply types:
• 1200W AC or DC power supply (ships standard with 4, 8, and 16-slot devices)
• 1800W AC or DC power supply
• 2100W AC or DC power supply (no longer available)
• 2400W AC or DC power supply
• 3000W AC or DC power supply
Brocade MLX Series and Brocade NetIron XMR routers support the following power supply options:
• 4-slot router: Supports 1200W and 1800W AC and DC power supplies.
• MLX and XMR devices can accommodate three 1200W power supplies. For power
redundancy you must purchase additional power supplies depending on how you populate
your router.
• MLXe devices can accommodate four 1200W or 1800W power supplies. For power
redundancy, you must purchase additional power supplies depending on how you populate
your router.
Active Below Pwr LED On The switch fabric is active and ready to switch user packets.
Off for
extended
period The switch fabric is not active and cannot switch user packets.
TABLE 24 Switch fabric module LEDs (Continued)
LED Position State Meaning