BNC 1105 Universal Counter - Manual (Page 35)

35 35 35 35
4
Front Panel Operations
This chapter will guide you through different ways of configuring
measurement functions. It contains information about how to change the
parameters and settings for your measurements and all the other front
panel operations for system settings. Remote interface settings are
described in Chapter 5.
4.1 Measurement Result and Status Display
The MODEL 1105 universal counter provides display of measurement
results along with the information on the channel of your choice. The
following options are available for all the measurement functions except
Voltage Peaks:
Please press Show Status softkey to check the messages located in the
right bottom corner of the display as shown in Figure 4-1. Then, pressing
the same softkey under the items to toggle the next information, for
example, the Input item will appear as shown in Figure 4-2.
Figure 4-1 Figure 4-2
Input: display the parameters of the input channel(s) as shown in
Figure 4-3.
Stats: display statistics (mean, std, ∆P-P and N) and the number of
measurements taken in getting the statistics as shown in Figure 4-4.
Limit: display the measurement results in graph mode as shown in
Figure 4-6.
Volt: display the maximum, minimum, Vc and Vpp voltages of the
input signal as shown in Figure 4-5.