BNC 1105 Universal Counter - Manual (Page 42)

42 42 42 42
Remote Interface Command
Auto arming:
[:SENSe]:TINTerval:ARM:ESTART:LAYer2:SOURce IMMediate
External arming:
[:SENSe]:TINTerval:ARM:ESTART:LAYer2:SOURce EXTernal
[:SENSe]:TINTerval:ARM:ESTART:LAYer2:SLOPe Positive|NEGative
For phase measurements:
Press the Other Meas and Gate & ExtArm buttons, and then toggle
between auto and external under the softkey ARM.
■ If Auto Arming is selected, the Counter automatically starts
continuous measurements.
■ If External Arming is selected, press the softkey under SLOPE to
toggle between Positive and Negative. This is to specify the slope of
the external start arm signal.
Remote Interface Command
Auto arming:
[:SENSe]:PHASe:ARM[:STARt]:SOURce IMMediate
External arming:
[:SENSe]:PHASe:ARM[:STARt]:SOURce EXTernal
[:SENSe]:PHASe:ARM[:STARt]:SLOPe Positive|NEGative
For totalize measurements:
Press the softkey under GATE to toggle from auto, time and external.
■ If Auto Arming is selected, the counter automatically starts
continuous measurements.
■ If Time Arming is selected, use the numeric keypad or the arrow keys
to select a desired gate time (refer to Ch.4.2.1). The time unit will be
displayed on the top-right corner.
■ If External Arming is selected, press the softkey under START to
STARt:SOURce Front-Panel Arming Mode
IMMediate Auto
EXTernal EXTERNAL
ESTART:LAY2:SOURce Front-Panel Arming Mode
IMMediate Auto
EXTernal EXTERNAL