BNC 1105 Universal Counter - Manual (Page 67)

67 67 67 67
NUCLEONICS CORPORATION to remotely control the universal counter
through USB, LAN or GBIP interface.
To set up the USB interface
The USB cord should be connected well between the MODEL 1105 and
user’s PC. Install the MODEL 1105 application in the PC and execute the
program. Click Tool tab for PT Assistant, then input commands.
To check USB ID
1. Press the UTILITY button and then the softkey under I/O to select
the I/O menu.
2. Press the softkey under SHOW USBID. The USB ID will then be
displayed.
To set up the GPIB interface
Insert GPIB interface card into the interface slot on the rear panel. Assign
an address for the interface. Then install the MODEL 1105 application in
the PC and execute the program. Click Tool tab for PT Assistant, then
type in commands.
How to assign GPIB address
1. Press Utility button and then the softkey under I/O to select the I/O
menu.
2. Press the softkey under “GPIB Addr” to specify the GPIB address as
shown in the Figure 5-3.
3. Use the numeric keypad or the arrow keys to input a desired address
(refer to Ch.4.2.1).
Figure 5-3
※ Note: The GPIB address is from 0 ~ 30.
LAN Configuration
To configure user’s local area network interface, A few parameters need
to be configured. Users may need to contact network administrators for
information to establish communication with the LAN interface.