SkyTrak 6036 Service Manual - Manual (Page 109)

Section 8. Engine
Model 6036 S/N 9B0499 and Before 8-23
15. Attach the throttle control cable to the engine
fuel injection pump as follows:
(a) Fasten the throttle cable to the throttle
cable bracket with a clamp being sure to
align the grooves in the cable and clamp.
(b) Secure the throttle cable clevis to the fuel
injection pump throttle and stop lever with
cotter and clevis pins. Adjust the clevis so
that the lever touches the stop screw.
16. Connect the fuel lines to the fuel pre-filter and
fuel filter assemblies.
17. Connect engine wire harness to the engine and
transmission components, Fig. 8.26:
• Starter
• Starter Ground Cable
• Starter Relay
• Neutral Start Switch (on transmission)
• Transmission Temperature Switch
• Low Oil Pressure Sender
• Emergency Pump Oil Pressure Switch
• Water Temperature Sender
• Fuel Run Solenoid
• Alternator
• Thermo Start Plug
18. Secure the rear support between the side frame
members with ten capscrews, lock washers,
and hex nuts. Torque to 225 to 275 lb-ft (306
to 374 N m).
19. Connect the wiring to the backup alarm.
20. Attach the exhaust system to the engine.
21. Install the air cleaner system on the rear
support and connect the hoses.
22. Install the radiator overflow bottle.
23. Install the radiator, hoses, and shroud.
24. Connect the radiator hoses to the engine.
25. Fill the radiator as follows:
(a) Be sure the radiator petcock is closed and
the engine cylinder block drain plug is
installed.
(b) Fill the radiator completely with 50/50
mixture of ethylene glycol and water.
Capacity is 5.4 gallons (20,4 liter).
(c) Replace radiator cap.
(d) Add coolant to the overflow bottle until it is
about 1/4 to 1/2 full—approximately 1 quart
(0,9 liter).
(e) Clean dirt and debris from radiator fins and
core. Remove rear radiator cover for
access to radiator.
26. Install the transmission oil cooler on the rear
support and connect it to the transmission.
27. Fill the transmission as follows:
(a) Install a cleaned drain plug and screen and
gasket, Fig. 7.1, into the transmission
sump housing.
(b) Fill transmission with Tractor Hydraulic
Fluid to LOW mark on dipstick, Fig. 7.6.
28. Install the radiator cover.
29. Install counterweight on the rear of the frame.
30. Check the fluid levels as follows:
(a) Start the engine and allow it to heat to
operating temperature. Do not operate
engine for more than two minutes.
(b) Shut the engine off, wait for engine to
cool, and check the coolant level. Top it
off as required by adding coolant through
the overflow bottle.
(c) Be sure the engine oil level is between the
full and add marks. If it is below the add
mark, add 10W30 motor oil equal to API,
SE CC or SE CD specifications. Engine
crankcase capacity is 9.4 quarts (8,9 liter)
with a filter change.
(d) Check the transmission oil level. If it is
below the add mark, add Tractor Hydraulic
Fluid to bring it to the full mark on the
dipstick. Transmission capacity is 4.3
gallons (16,3 liter).
31. Install the transmission cover and close and
lock both engine access doors.