SkyTrak 6036 Service Manual - Manual (Page 23)

Model 6036 S/N 9B0499 and Before 3-5
Section 3. Boom
GAP MUST BE 0.07 TO
O.13" (1,8 TO 3,3 mm)
GAP MUST BE 0.07 TO
O.13" (1,8 TO 3,3 mm)
GAP MUST BE 0.07 TO
O.13" (1,8 TO 3,3 mm)
PAD, INSERT (1),
LOCK WASHER (3),
FLAT WASHER (3),
3/8-16 X 7/8"
CAPSCREW (3)
PAD, INSERT (1),
LOCK WASHER (3),
FLAT WASHER (3),
3/8-16 X 7/8"
CAPSCREW (3)
PAD, #10 GA SHIM,
INSERT (2),
LOCK WASHER (4),
FLAT WASHER (4),
3/8-16 X 3/4"
CAPSCREW (4)
INTERMEDIATE
BOOM
OUTER BOOM
3.1.3 Outer Boom Replacement
a. Removal
1. Refer to paragraphs 3.1.1.a and 3.1.2.a and
remove the inner and intermediate booms.
2. Disconnect and remove the extend and retract
chains from the outer boom. Check the
condition of the chains and replace if worn or
damaged.
3 Refer to paragraph 9.2.2.a and remove the
boom extend/retract cylinder.
4. Refer to Fig. 3.7 and remove the locknut and
capscrew that secures the slave cylinder rod
end pin. Remove the pin. Check the condition
of the bearing in the cylinder rod end; replace
bearing if worn or damaged.
5. Refer to Fig. 3.8 and disconnect the grille tilt
cylinder hoses from the tubing at the hose
guides and remove the hoses from the boom.
Fig. 3.6 Rear Wear Pads Attached to Intermediate Boom
HOIST CYLINDER
ROD END PIN
BOOM PIVOT
PIN
OUTER BOOM
FRAME
EXTEND/RETRACT
CYLINDER BASE
END PIN
SLAVE CYLINDER
ROD END PIN
Fig. 3.7 Outer Boom Pivot Pins
MA0061
MA0071
PAD, SPACER, #10 GA
SHIM, INSERT (1),
LOCK WASHER (2),
FLAT WASHER (2),
3/8-16 X 2"
CAPSCREW (2)