SkyTrak 6036 Service Manual - Manual (Page 180)

9-67 Model 6036 S/N 9B0499 and Before
Section 9. Hydraulic System
5. Disconnect red electrical cable from power
terminal on solenoid.
6. Tag, disconnect, and plug the hydraulic supply
hose (1) at the connector (2). Wire or otherwise
secure the hose to the frame to hold it up and
prevent oil from draining out of the reservoir.
Cap the connector.
7. Tag, disconnect, and plug the pump outlet
hose (3) at the elbow (4). Cap the elbow.
8. Have an assistant support the pump and motor
assembly while removing two capscrews (5)
and lock washers (6) and remove from the
forklift.
9.4.2 Steering and Emergency Brake
Pump (S/N 7P0013 and Before)
a. Removal
1. Engage the park lock, place the travel selector
lever in neutral, and stop the engine.
2. Slowly loosen the fittings on the steering and
emergency brake pump as required to relieve
any trapped pressure
3. Tag and disconnect yellow ground wire from
ground terminal of motor (15, Fig. 9.44).
4. Tag and disconnect wire from switch terminal
on solenoid (10).
1. Supply Hose
2. Connector
3. Pump Outlet Hose
4. Elbow
5. Capscrew (2)
6. Lock Washer (2)
7. Terminal Cable
8. Screw (2)
9. Washer (2)
10. Solenoid
11. Capscrew (4)
12. Washer (4)
13. Pump
14. Coupling
15. Motor
16. Ground Strap
Fig. 9.44 Steer and Emergency Brake Pump and Motor (S/N 7P0013 and Before)
2
3
4
13
14
5 7
10
8
11
9
12
6
15
1
Warning !
Relieve hydraulic pressure before servicing any
hydraulic component. Escaping hydraulic fluid
under pressure can penetrate the skin causing
serious injury.
Warning !
Wait for the hydraulic fluid to cool before servic-
ing any hydraulic component. Hot hydraulic fluid
can cause severe burns.
MA0841