SkyTrak 6036 Service Manual - Manual (Page 58)

Section 5. Wheel Assembly, Tires, and Axle
5-13 Model 6036 S/N 9B0499 and Before
3. Place adequate support under the frame so
that it will remain in place when the axle
assembly is removed.
4. Remove the wheels from the axle as described
in paragraph 5.1.3.
5. Use floor jacks or install a suitable hoist at the
ends of the axle. Take up the slack.
6. Disconnect hydraulic hoses as required from
steering cylinders, service brakes and park
lock.
7. Remove the drive shaft from the axle input
shaft end yoke, Fig. 5.7.
8. Remove the capscrew and locknut securing the
axle pivot pin to the frame. Remove the pivot
pin and shims.
NOTE: To remove the pivot pin from the front axle:
• thread a 1/2" bolt into front end of pin and pull
or pry on bolt or drain fuel from fuel tank.
or
• remove tank and drive pin out from the back
side.
Fig. 5.7 Axle Connections
Warning !
9. At the front axle, remove two retaining rings from the frame tilt cylinder rod end pin, Fig. 5.7. Tap the pin
from the mounting blocks.
10. Using the hoist, remove the axle from the
frame and place it on a support at three points
of the housing. A suitable holding stand is
desirable, but not necessary. Refer to Spicer
®
Dana Maintenance Manual for Axle Models PS/
PR-7036 for internal servicing instructions.
b. Installation
1. Using a suitable hoist, remove the axle from its
support or stand and position it under the frame
so that pivot pin holes are aligned with hole in
axle.
2. Install the axle pivot pin and shims. There
must be no more than a 0.10" (2,5 mm) gap
between the frame and axle. Secure the pin in
place with a capscrew and locknut. Tighten
locknut until snug against collar, then an
additional 1/4 turn.
3. Secure the frame tilt cylinder rod end to the
frame mounting blocks, Fig. 5.7, with a pin and
two retaining rings. The pin must pass easily
through both mounting blocks. If not, shim the
blocks as required. Lubricate the pin using the
grease fitting on the cylinder rod.
4. Install the drive shaft on the axle input shaft
end yoke. Be sure retaining rings are securely
seated.
1. Drive Flange (items 2 thru 16)
Wheel End (items 17 thru 43)
FRAME
FRAME
SHIMS
AXLE PIVOT PIN
DRIVE
SHAFT
END YOKE
AXLE
FRAME TILT
CYLINDER
FRAME TILT
CYLINDER ROD
END PIN
MOUNTING
BLOCK
AXLE
MA0261
Wait for the hydraulic fluid to cool before
servicing any hydraulic component. Hot hy-
draulic fluid can cause severe burns.