SkyTrak 6036 Service Manual - Manual (Page 38)

4-2 Model 6036 S/N 9B0499 and Before
Section 4. Operator's Cab
terminates at a linkage which moves a spool in the
transmission control valve.
a. Transmission Shifter
Removal
1. Remove lower panel, Fig. 4.2, below the
control console.
2. Remove the clamps that secure the control
cables to the angle brackets.
3. Remove the cotter pins and washers that
attach the swivels to the bellcranks. Label and
remove the cables from the shifter assembly,
Fig. 4.3. Remove the swivel from the end of
each cable by turning it counterclockwise
4. Disconnect the reverse switch red and black
lead wires from the wiring harness.
5. Remove the shifter assembly from the control
console.
BELL CRANKS
SWIVEL
LOCKNUT
REVERSE SWITCH
REVERSE
SWITCH
LEAD
WIRES
GATE PLATE
CLEVIS PIN, WASHER, AND
COTTER PIN
COTTER PIN AND WASHER
CABLE MOUNTING STRAP
CONTROL CABLE
ANGLE BRACKET
LOCKNUT AND CAPSCREW
CLAMP
SHIFTER ASSEMBLY
TRAVEL SELECT
LEVER FOR
FORWARD-F,
NEUTRAL-N, AND
REVERSE-R
RANGE SELECT
LEVER FOR LOW-1,
MEDIUM-2, AND
HIGH-3
Fig. 4.3 Shifter Assembly
4.2.1 Steering Wheel and Steering Unit
The steering wheel changes the direction of forklift
travel in two-wheel, four-wheel, or crab steering
modes as designated by the steering select
switch. Refer to your Owners/Operators Manual
for a description of these steering modes.
The wheel is attached to the steering unit with a
nut that must be torqued to 50 lb-ft (68 N m). The
steering unit is attached to the control console with
four flange-head screws and lock washers.
4.2.2 Travel Select and
Range Select Levers
Use the travel select lever to place transmission in
Forward-F, Neutral-N, and Reverse-R and the
range select lever to select Low-1, Medium-2, and
High-3 gears.
The levers are mounted in a transmission shifter
assembly, Fig. 4.3. A cable attached to each lever
MA0141