SkyTrak 6036 Service Manual - Manual (Page 271)

Section 10. Electrical System
Model 6036 S/N 9B0499 and Before 10-77
Trouble Probable Cause Remedy Reference
Optional Light Circuit—MOMENTARY BRAKE LIGHT (STOP LIGHT) AND SWITCH
Stop and tail light
bulbs fail to light
when brake pedal
is pressed. Replace stop and tail light
bulb(s).
Replace momentary brake
switch.
See para. 10.9.2
See para. 10.9.2
Optional Light Circuit—HEADLIGHT AND REAR WORK LIGHT SWITCH
One headlight or
rear work light is
inoperative or
intermittent. 1. Loose connection.
2. Defective sealed beam
unit.
Secure connections to
headlight including ground
wire (black wire).
Replace sealed beam unit.
See para. 10.9.4
See para. 10.9.4
1. Stop and tail light bulb(s)
(23, Fig. 10.53) are burned
out.
2. Momentary brake switch
(9) is open when brake
pedal is pressed.
One or more
headlights are
dim. 1. Open ground connection at
headlight.
2. Black wire mislocated in
headlight connector (three
wire, hi-lo connector only).
Repair black wire connection
between sealed beam and
body ground.
Relocate black wire in
connector.
See para. 10.9.4
See para. 10.9.4
Momentary brake
bulbs remain ON
when brake pedal
is released. 1. Momentary brake switch
(9) is closed when brake
pedal is released.
2. Short in wiring.
Replace momentary brake
switch.
Remedy cause of short.
See para. 10.9.3
See para. 10.9.3
One or more
headlights have a
short life. Charge circuit problem. Refer to charge circuit
troubleshooting. See para. 10.6