SkyTrak 6036 Service Manual - Manual (Page 26)

Section 3. Boom
3-8 Model 6036 S/N 9B0499 and Before
pads and the intermediate boom. The gap
should be 0.07 to 0.13" (1,8 to 3,3 mm) and
equal on all sides. Remove or install shims as
required.
IMPORTANT: The ends of wear pad attaching
capscrews must not protrude beyond the wear pad
insert; the ends must range from flush to 0.19" (5
mm) recessed in the wear pad insert (refer to Fig.
3.3).
17. Install the wear pads by applying Loctite 242 to
the capscrews and torquing them to 31 lb-ft (42
N m).
18. Lubricate the outer boom pivot pins, Fig. 3.7,
with multi-purpose lithium based grease.
11. Attach the two extend chains at the chain
yoke, Fig. 3.11, on top of the boom. Allow the
remaining ends of the chains to hang free until
the intermediate boom has been installed.
12. Attach the retract chain at the chain support
plate, Fig. 3.11, and route it along the bottom of
the outer boom to the rear boom cover opening.
13. Remove hoist and sling from outer boom.
14. Remove cribbing from front of boom.
15. Refer to paragraphs 3.1.2.b and 3.1.1.b and
install the intermediate and inner booms.
16. Refer to Fig. 3.9 and check the wear pad gap
between the front outer boom side and top wear
Fig. 3.11 Chain Replacement
INNER
BOOM
1-1/2"
TO
2-1/2"
(38 mm
TO
63 mm)
INTERMEDIATE
BOOM
SHOULDER
SCREW AND
LOCKNUT CLEVIS
CHAIN LINK
SHOULDER
SCREW AND
LOCKNUT
YOKE
INNER BOOM
INNER BOOM
RETRACT CHAIN
LOCKNUT AND
FLAT WASHER
OUTER BOOM
RETRACT CHAIN
LOCKNUT AND
FLAT WASHER
INTERMEDIATE BOOM
PIN AND
RETAINING
RING
CHAIN
SUPPORT
PLATE
RETRACT
CHAIN
OUTER BOOM
EXTEND CHAIN
EXTEND CHAIN,
LOCKNUT AND
FLAT WASHER
BLOCK
MA0111