SkyTrak 6036 Operation Manual - Manual (Page 18)

Page 12 6036/6036T
Figure 1
OH0050
STEERING WHEEL
IGNITION SWITCH
SERVICE BRAKE PEDAL
ACCELERATOR PEDAL
Controls
Ignition Switch (See Figure 1)
Using the ignition switch key, the switch may be turned
clockwise from the OFF position to the RUN, THERMO
START and START positions. The THERMO START
and START positions are spring-loaded to return to the
RUN position and must be manually held in place for
cold starting or normal starting.
Off position — The entire electrical system is shut down.
Run position — All controls and indicators are operable.
Thermo Start position — (Perkins Engines ONLY)
Energizes a cold starting system in the intake manifold
to pre-heat the intake air for cold starting. (Not appli-
cable for Cummins Engines.)
Start position — Engages starter to crank the engine
when the emergency brake is engaged and the trans-
mission is in neutral.
Service Brake Pedal (See Figure 1)
Pressing down the brake pedal applies the wet disc
service brakes located in the axle wheel ends.
Operation
Accelerator Pedal (See Figure 1)
Pressing down the accelerator pedal increases travel
speed of the vehicle. The pedal is spring-loaded to
return to idle speed.
Steering Wheel (See Figure 1)
Turning the steering wheel to the left or right steers the
vehicle in the corresponding direction. Any one of three
steering modes are selectable. Refer to "Steering
Select Switch."