SkyTrak 6036 Operation Manual - Manual (Page 76)

Page 70
6036/6036T
2. Clean area around axle fill/level plug, remove plug
(Figure 48) from axle housing and check oil level.
Add 80W90 gear oil as required to bring the oil
level up even with the plug hole (for temperatures
below -15° F (-26° C) 75W gear oil can be used).
3. Reinstall plug.
B. Oil Change (1000 Hour Intervals)
1. Level the vehicle, ground the carriage, place
travel select lever in (N) Neutral, engage the
emergency brake switch and shut off engine.
2. Clean area around axle fill/level plug and drain plug.
3. Place receptacle under the axle housing drain
plug. Remove fill/level plug and drain plug from
axle housing.
4. Allow oil to drain completely.
5. Clean and reinstall drain plug.
ENGINE FLYWHEEL
MOUNTING FLANGE
PLUG AND
SCREEN
GASKET
Figure 47
TRANSMISSION
OA0413
7. Fill transmission with MIL-L-2104C Oil (See table
on page 68.) to the LOW mark on dipstick (Figure
46).
8. Check transmission level and add oil as required
following procedures in paragraph 8A.
9. Axle Oil
A. Level Check (250 Hour Intervals)
1. Level the vehicle, ground the carriage, place travel
select lever in (N) Neutral, engage the emergency
brake switch and shut off engine.